Allmand Maxi-Power MP25 T4F, Operator'S Manual

Page: 24 / 68

Not for
Reproduction
24 ALLMAND.COM
3. Operation
3-11
3.4.4 Check Fuel
Before starting operation, make sure to check the level of residual fuel so that fuel shortage during
operation can be avoided. If necessary, drain condensate accumulated at the bottom of the fuel tank.

Refilling fuel tank should be done in an outdoor well-ventilated place.

Do not fill fuel up to the filler level.
When fuel tank is filled up to the filler level, the expansion volume of the tank is too small and
could lead to problems with fuel flow and containment. Furthermore, fuel may spill from the fuel
tank due to vibration caused during movement or transportation of the unit.
※
When using an external fuel tank, note that the Fuel Level indication on the monitor will not
reflect the actual fuel level.
D004

Do not, under any circumstance, bring lit cigarettes and/or matches
to the fuel.

The fuel is extremely flammable and dangerous. Be careful of fire
because the fuel is very likely to catch fire.

Refuel only after stopping the engine, and never leave open fuel
can near the machine. Do not spill. It could cause a fire. When it is
spilt, wipe it up completely.

Never use alcohol-base cleaning fluid. If it sticks to such parts made
of plastic, it causes degradation of liquid surface visibility, and, in
the worst case, can lead to cracking and result in fuel leaks.
3.4.5 Check Fuel Filter Drain
If the red float [A] inside the fuel filter is above line, drain water from the fuel filter.
A180796
<Procedure>
1.
2.
Before draining water, attach a drain hose to the drain plug [B].
Prepare a container. Loosen drain plug [B] and air bleeding plug [C]
to drain.
3. After draining finished, be sure to tighten [B] and [C].

Do not remove fuel filter case [A] as fuel is overflow if it is
removed. If it is necessary to remove it, plug inlet hose with a clip
etc.

Drain the condensate into a container, and then dispose of
condensate according to the designated regulations.
C
Outlet Inlet
Priming pump
A
B
Element
Water
drain level