Allied H12E, Service Manual

Page: 11 / 121

Section 1
1 - 3
Serial Number Codes
The serial number codes are described on page 1-2 of
this manual. The nameplate with the serial number code
is found on the top left hand side of the winch case. The
serial number code is also stamped on the left hand side
of the winch frame.
Nameplate
The rated capacity for the winch, as it is equipped, is
shown on the nameplate. Each winch is shipped from the
factory with a nameplate as shown in Figure 1-3. If the
nameplate is missing, or the wire rope does not match the
information on the nameplate, do not operate the winch
until its capacity is known and a new nameplate is installed.
Each winch must be operated within its rated capacity as
shown on the nameplate.
Figure 1-3 Nameplate
ALLIED SYSTEMS COMPANY
21433 SW OREGON STREET
SHERWOOD, OREGON 97140 USA
WWW.ALLIEDSYSTEMS.COM
MODEL:
SERIAL NO.:
MAXIMUM LINE PULL*
BARE DRUM:
MAXIMUM WIRE
ROPE DIAMETER:
*LIMITED BY WIRE BREAKING STRENGTH. MAY BE LOWER DUE
TO AVAILABLE POWER FROM WINCH CARRIER. CONTINUOUS
LINE PULLS SHOULD BE LESS THAN WINCH CARRIER GVW.
MADE IN USA 2315005 REV A