Section 4
4 - 43
1.
Install inner bearing assembly if previously removed.
Install drum pinion gear. Use a liberal amount of
lubriplate or other light lube grease to hold the inner
bearing cone in place.
2.
Position intermediate gear in housing, and then install
intermediate shaft.
NOTE: Install intermediate gear with high shoulder
as shown above.
3.
Install the outer bearing cup and cone. Make sure
that the cup is fi rmly seated against the bearing cone.
4.
Apply 1/8” bead of RTV sealant (e.g., Loctite 593
RTV) to the winch frame. Install shim pack (if
necessary).
5.
Apply 1/8” bead of RTV sealant (e.g., Loctite 593 RTV)
to the intermediate shaft cover. Install intermediate
shaft cover, then tighten the six capscrews to 165
ft-lbs (225 N-m).
Summary of Contents for H12E
