Allied H12E, Service Manual

Page: 82 / 121

Section 4
4 - 7
10. Remove and discard O-ring from the right-hand end
of the drum.
NOTE: This O-ring must be replaced with a new
Allied Systems Company-approved O-ring during
reassembly.
11. Remove oil seal (note the orientation of the seal lip
for replacement), seal spacer with O-ring, and double
tapered roller bearing assembly from the left-hand
end of the drum. Discard the oil seal.
NOTE: Bearing, cups and spacers are a matched set,
and must not be interchanged with other bearing set
components.
NOTE: Refer to Figure 4-2 on page 4-5 for location of
components.
12. Using a suitable lifting device, the drum gear can
now be removed.
13. Remove and discard the oil seal from the right-hand
side of winch housing.
NOTE: This seal must be replaced with a new Allied
Systems Company-approved seal during reassembly.