Advanced parameters and commands
Goldeye Technical Manual
V2.2.0
74
Integrator and image store (H)
The
integrator / image store
module is internally applied for the automatic
selection of the correction set (
k=
) and the recording of new temporary
reference image data (
A=FF
,
B=FF
). Furthermore this module may also be
controlled manually. The data are stored in the volatile SDRAM memory. They
get lost after the camera is switched off.
The bits of the parameter value are divided into four different sized bit groups
a
,
b
,
c
and
d
. Each bit group has a special function, being independent of the
other ones:
•
a
: Controls the output of integrator module. Either the incoming data are
passed through transparently or the actual memory content of the inte-
grator is output. In the latter case the integrator becomes an image
source itself. In this way this module has a simple image store function.
•
b
: Defines the number of images to be integrated and starts the
integration process as soon as a new value was set.
•
c
: Controls the data copy mode. The image store content of the integrator
is copied into the correction data store as low or high reference image of
the two-point correction (parameter
A
or
B
in the active memory page
S
) at any time. The data copy mode should stay active for a minimum
period of two complete image cycles in order to guarantee a save data
transmission into the target area.
•
d
: Indicates whether the last started integration is still running. This bit
can only be read out; during write access to
H
it is ignored.
GigE Feature Name
Feature Visibility
Description
BPC_OperationMode
Expert
Operation mode of the bad pixel
correction
(F=<value> command)
BPC_CorrectionData_FileNumber Expert
File number of the correction data
for the bad pixel correction.
(C=<value> command)
Table 39: GigE feature: Bad pixel correction (BPC)
