CentreCOM
AT-3624TS/AT-3624TRS
Repeaters
9
The following procedure details how to install an AT-3600 Series slave
module in a managed hub configuration in a concentrator chassis:
1.
Check to be sure another module is already functioning as the Master
unit in the chassis.
2.
Remove the interrepeater bus dust cover from the back of any newly
shipped AT-3600 slave module before installing it in a multi-module
chassis. The interrepeater bus port is located on the back panel of every
AT-3600 module. See Figure 5.
3.
Remove the rubber feet from the bottom of any newly shipped AT-3600
Series module before installing it in a multi-module chassis. See
Figure 6.
4.
Reinstall the screws, after removing the rubber feet, to prevent the
module casing from expanding and warping.
Figure 5: Removing the
Interrepeater Bus
Dust Cover
Figure 6: Removing Rubber
Feet from Module
INTERREPEA
TER BUS
FIRMW
ARE CASSET
TE
STA
TUS
POWER
MASTER
FAUL
T
INTERREPEA
TER BUS
FIRMW
ARE CASSET
TE
STA
TUS
POWER
MASTER
FAUL
T
IEEE 802.3
/ ETHERNET 1
0 BASE
2
8 PORT HUB
/ REPEA
TER
with Network Management
AT-36xx with dust cover installed
AT-36xx with dust cover removed
Dust Cover
Interrepeater Bus
Port Connector
InterrepeaterBus
Port Connector
AT-36xx with dust cover installed
AT-36xx with dust cover removed
Dust Cover
AUI
Rubber foot
(1 of 4)
Reinstall
all 4 screws
