Allied Telesis AT-TQ Series, User Manual, Page: 90 / 174

Chapter 3: Manage Menu
90
2. Click the Enabled dialog circle for the Managed AP Administrative
Mode parameter. This is the default setting.
3. Enter the IP addresses or domain names of up to four controllers in the
Controller IP Address fields. The controllers are management
workstations that have the AT-UWC program.
The access point queries the controllers in the order in which they are
listed, starting with IP address 1. Please observe the following
guidelines if you specify the controllers by their domain names:
 The first character must be alphanumeric. It cannot be a special
character.
 The last character cannot be a hyphen or period.
4. Click the Base IP Port field and enter the starting TCP/UDP port
number of the range of 10 port numbers that the access point uses to
communicate with the controller. Here are the guidelines to setting the
base IP port:

The range is 1 to 65000. The default is 57775 for the range 57775
to 57784.
 You must assign the same value to the root and satellite access
points.
 You must also enter the same value on the controller.
5. Click the Edit dialog box for the Pass Phrase field to remove the check
mark.
6. Click the Pass Phrase field and enter the passphrase for the access
point. Here are the guidelines for the passphrase:

You must assign the same passphrase to the root and satellite
access points of a group.
 The passphrase can be from 8 to 63 characters.
 It can consist of letters and numbers, but no spaces.
 It is case sensitive.
 You must enter the same passphrase on the controller.
 You may leave the passphrase blank.
7. Click the Edit dialog box again for the Pass Phrase field.
8. For the WDS Managed Mode parameter, click the Root AP dialog
circle if the unit is to be the root access point and communicate with
the controller through its LAN port, or the Satellite AP dialog circle if
the device is to communicate with the controller through a root access
point.