Allied Telesis AT-TQ Series, User Manual, Page: 80 / 174

Chapter 3: Manage Menu
80
5. Click the Encryption pull-down menu and select the encryption method
for the WDS bridge. The available selections depend on the radio
mode and VAP0 security level. Refer to Table 8 on page 75 for the
available security levels. If you do not want the bridge to use
encryption, select None, the default setting.
6. Configure the settings of the encryption method.
The encryption parameters are described in the following sections:
 “Static WEP” on page 80
 “WPA Personal” on page 82
7. After configuring the encryption settings, click the Update button to
activate and save your changes on the access point.
8. Log off to end your management session on the access point.
9. Start a management session on the other access point of the WDS
bridge.
10. Repeat “Preparing the Access Point for the WDS Bridge” on page 77
and this procedure to configure the WDS bridge on the other access
point. Be sure to assign the same values to the parameters.
Static WEP
The static WEP parameters are shown in Figure 23 and described in
Table 9.
Figure 23. Static WEP on WDS Bridges
Table 9. Static WEP on WDS Links
Field Description
Key Length Select either 64 or 128 bits for the key
length. The default is 128 bits.