Chapter 2: Installing the Hardware
28
Installing the Standard Bracket on the Adapter
If you are installing AT-ANC10S/2 adapter in a computer that requires a
standard bracket, you must replace the pre-installed low profile bracket on
the adapter with the standard bracket. To install the standard bracket,
perform the following procedure:
To replace the low-profile bracket with the standard bracket, do the
following:
1. Remove the screws that attach the bracket to the adapter. See
Figure 4. Removing the Low-profile Bracket
2. Fit the standard bracket onto the adapter as shown in Figure 5 on
page 29 and secure with the two screws.
Summary of Contents for AT-ANC10S
