Allied Telesis AT-ANC10S, Installation And User Manual

Page: 43 / 124

AT-ANC10S/2 Adapter Installation and User’s Guide
43
or, for Linux 2.6 kernels:
rmmod bnx2x
insmod bnx2x.ko
4. Install the driver and man page by entering the following command:
make install
Note
See the “Installing the Source RPM Package” on page 41 for the
location of the installed driver.
To configure the network protocol and address after building the driver,
refer to the manuals supplied with your operating system.
Unloading the
Linux Driver
You can unload, or remove, the Linux Driver from an RPM or TAR
installation. See the following:
 “Unloading the Driver from an RPM Installation” on page 43
 “Unloading the Driver from a TAR Installation” on page 43
Unloading the Driver from an RPM Installation
This section describes how to unload, or remove, a Linux driver from an
RPM installation.
Note
On 2.6 kernels, it is not necessary to bring down the eth# interfaces
before unloading the driver module.
To unload the driver, use
ifconfig
to bring down all eth# interfaces
opened by the driver, and then enter:
rmmod bnx2x
If the driver was installed using the
rpm
command, enter the following
command to remove it:
rpm -e netxtreme2
Unloading the Driver from a TAR Installation
If the driver was installed using make install from the tar file, manually
delete the bnx2x.o or bnx2x.ko driver file from the operating system. See
“Installing the Source RPM Package” on page 41 for the location of the
installed driver.