Allied Telesis AR100 series, User Manual

Page: 128 / 128

10-128 AR100 Series Internet Router User Guide
13. Intended Use
This equipment is not intended for use in a computer room as defined in the
standard for the Protection of Electronic Computer/Data Processing
Equipment ANSI/NFPA 75 relating to North America only.
14. US Federal Communications Commission (FCC)
This equipment complies with Part 15 of FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Properly shielded and grounded cables and connectors must be used in order
to meet FCC emission limits. Proper cables and connectors are available from
Allied Telesyn authorised distributors and resellers. Allied Telesyn is not
responsible for any radio or television interference caused by using other than
recommended cables and connectors or by unauthorised changes or
modifications to this equipment. Unauthorised changes or modifications could
void the user's authority to operate the equipment.
16. Canadian Department of Communications
This digital apparatus does not exceed the limits for radio noise emissions from
digital apparatus as set out in the Radio Interface Regulations of the Canadian
Department of Communications.
Le present appareil numerique n’emet pas de bruits radioelectriques depassant
les limites applicables aux appareils numeriques prescrites dans le Reglement
sur le brouillage radioelectrique edicte par le ministere des Communications
du Canada.
17. Telepermit PTC 231/97/027
The VOX ports on AR300 Series routers comply with specification PTC 100 for
connection to the New Zealand Telecom Network.
Not all standard phones/faxes etc. will respond to incoming ringing. This may
not be a fault, and could be due to incompatability between the TA and the
CPE. Check with a phone which is known to ring before reporting a fault.
Telecom “Smart” services which are accessed via switch-hook flash, will not be
accessible to CPE connected to the TA.
Environmental Conditions
This apparatus is designed for operation under the following environmental
conditions:
Operating Temperature -5ºC to 40ºC
Storage Temperature -5ºC to 70ºC
Humidity 5% to 95% non condensing
Operating Atmospheric Pressure 86 kPa to 106 kPa