© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Washer Operation
202065R6
10
Signals
There are five options when a signal can be used during
the washer operation. These five options are listed below:
1.
End of Cycle Signal
By default, this signal is turned off. If turned on, the
signal sounds for three (3) seconds at the end of a
cycle.
2.
Signal On Keypad Depression
By default, this signal is turned on and sounds for
a quarter of a second each time a keypad is pressed.
3.
Signal On Coin Drop/Card Insertion
By default, this signal is turned on and will sound
for a quarter of a second each time a coin or card
is entered.
4.
Signal for Card Removal (Card Models Only)
By default, this signal is turned on and will sound
one second on and one second off when the
control is prompting for card removal.
5.
Signal for Start
By default, this signal is turned on and will sound
one second on and one second off for 10 seconds
after vend price has been satisfied.
NOTE: Refer to
Programming Control
to program
signal options.
Changing Cycles
Cycles and wash temperatures can be changed anytime
during the first fill step. (If certain types of card
readers are connected to the machine, the cycle can’t
be changed after START is pressed.) After the first fill
step, all key presses are ignored.
Selecting a higher priced wash temperature or cycle type
will stop the first fill cycle, and
INSERT COINS/CARD
will flash one (1) second on and one (1) second off until
the vend price has been satisfied. After the vend price has
been satisfied, the cycle will restart with the new
selection. If the vend price is not satisfied within 1
minute, the washer control will go back to the
previously set wash temperature and cycle selection.
