ALLIANCE SWNLC2PP111TW01, Manual

Page: 71 / 104

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming Control
69
202065R6
25. Cycle Modifier Programming
“CnP”
This option allows the owner to program the machine
to offer extra wash time, extra rinse time, warm rinse,
or any combination of these to the customer for an
added vend price. This option is activated when
HEAVY is selected using the CYCLE SELECT/SOIL
LEVEL keypad.
How to Program Heavy Cycle Selection
Vend Price “CnP1”
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode .
2. Press the DELICATES ( ) or the COLD ( )
keypad until “ Prog ” appears in the display. Press
the START (enter) keypad and “ AtS1 ” will
appear in the display.
3. Press the DELICATES ( ) or the COLD ( )
keypad to scroll through the programmable
options until “ CnP- ” appears in the display. Press
the START (enter) keypad and “ CnP1 ” will
appear in the display.
4. When “ CnP1 ” appears in the display, press the
START (enter) keypad. There are five digits in
the Heavy Cycle Selection Vend Price. The fifth
digit will appear in the display and will flash for
one second on, one second off. Refer to
Figure 25 .
NOTE: If the vend price is 10000 or more, the fifth
digit is “ 1-6 ”. If the vend price is 9999 or less, the
fifth digit is “ 0 ”.
Figure 25
5. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the value of the
fifth digit.
NOTE: The vend price can be set from 1 to 65,535.
The factory default setting is 25.
6. Press the START (enter) keypad to enter the fifth
digit and display remaining four digits. The
active digit will flash one second on and one
second off.
NOTE: To go back to the current programmable
option without changing the value, press the
WARM (<) keypad.
7. Press the DELICATES ( ) or the COLD ( )
keypad to increase or decrease the value of the
active digit and the START (enter) keypad to
enter the value of the digit and advance to the
next digit.
8. Press the START (enter) keypad with the last
active digit. The next Cycle Modifier option,
“ CnP2 ”, will appear in the display.
NOTE: To program “CnP2” (Heavy Cycle
Selection Option), continue to next Cycle Modifier
option. To program other options, press the
WARM (<) keypad and refer to the appropriate
section.
How to Exit Programming Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
CHM507R
>
<
>
<
> <
>
<