© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
85
202065R6
Collecting Audit Information
This feature allows the owner to retrieve audit
information stored in the washer by pressing a sequence
of pads on the control. For an explanation of the audit
options available, refer to the Audit Options List on this
page.
How to Enter Audit Feature
There are two methods the owner can use to enter the
Audit Feature.
Entering the Audit Feature by Manual Mode
1. Control must be in Manual Mode to start. Refer
to
Entering the Manual Mode
.
2. Press the DELICATES ( ) or the COLD ( )
keypad until “
AUdT
” appears.
3. Press the START keypad. “
CyC
” will appear.
If the procedure did not work, the control will return to
the Ready Mode.
Entering the Audit Feature with the Coin
Vault Open
1. Open coin vault. The service door must be
closed, and have remained closed for 4.25
minutes.
2. Press the START (enter) keypad.
NOTE: If the Audit Feature was entered during an
active cycle, the machine will continue to run.
How to Read Audit Data
1. Use the DELICATES ( ) or the COLD ( )
keypad to scroll through various options until the
desired option is shown in the display. Refer to
the Audit Options List,
Table 10
, for an
explanation of the audit options available.
2. Once the desired option appears in the display,
press the START (enter) keypad
once
to start the
audit count. At this point, the display will show
the first four-digit segment of the audit value. If
the audit count is 10,000 or higher, press the
START (enter) keypad again to view the last four
digits of the number.
NOTE: The display can show up to 4 digits at one
time. Audit counts 10,000 or higher are separated
into two 4-digit segments. Each time the START
(enter) keypad is pressed in step 2, the display will
show the next four-digit segment in the audit value.
For Example: In the Total Number of Coins #1 option
with “
COI1
” shown in the display, the audit has
counted 10,009 coins. Pressing the START (enter)
keypad one time will show “
_ _ _ 1
” to represent ten
thousand. Pressing the START (enter) keypad a second
time will display “
0009
” meaning nine. The total
equals “
00010009
” or 10,009.
3. Press the START (enter) keypad again. The
control will go to the next audit option in the
Audit Options List.
4. To select other audit options, repeat steps 1 – 4.
How to Exit Audit Feature
Press the WARM (<) keypad until the control returns
to Ready Mode.
NOTE: To exit Audit Feature when using Coin
Vault method, owner must close coin vault. The
control will then return to the previous mode of
operation.
Audit Options List
Display
Description
“
CyC
”
Total # of machine cycles
“
COI1
”
Total # of coins #1
“
COI2
”
Total # of coins #2
“
PLSE
”
Total # of Start Pulses
Table 10
>
<
>
<
