Allett BUFFALO 24", Operator And Parts Manual

Page: 21 / 68

15
WARNING - PREVENT ACCIDENTS
Always wear suitable safety gloves when working with the blade and cylinder.
Adjusting the height of cut
•
Always set the bottom blade to the correct position before attempting to set the
height of cut.
•
The height is set using the setting bar provided. The bolt on this should be
adjusted until it reaches the desired
height of cut (X).
•
Once adjusted, position the setting
bar so that the underside of the bolt
head (X) rests on top of the leading
edge of the bottom blade and the
rearward end of the bar makes
contact with the underside of the rear
roller.
•
It is essential that the rear of the bar is
under the centre of the rear roller, this
may require the machine to be driven
onto blocks to aid access.
•
Adjust the height of the front roller until the setting bar just touches it.
•
To adjust the position of the front roller:
-
Locate the fasteners which secure the
front roller adjuster brackets, these can
be found at the front of the machine on
each side of the chassis as shown.
-
Loosen the fasteners so that the
brackets can freely slide up and down,
set the height using the bar as
described above and re-torque the
fasteners.
Do not overtighten