Allen-Bradley ControlLogix 1756-ENBT, User Manual

Page: 45 / 144

Publication 1756-UM050A-EN-P - December 2001
Configuring the 1756-ENBT Module 4-11
zappa2:\
tc=icp.defaults:\
ha=0000bc034022:\
ip=130.151.132.123
To use a BootP server to configure the 1756-ENBT module perform
the following steps:
1. Access and open the BootP tab file using a text editor.
2. Enter the IP address of your module.
If you need more information on setting IP addresses, refer to
pages 3-3 to 3-4.
3. Use the text editor to enter the Ethernet hardware address
(MAC ID) of your module. You must enter all digits, including
zeroes.
If you change or replace this 1756-ENBT module, you must enter
the new Ethernet hardware address of the module when you
configure the new module.
4. Enter the optional Gateway Address.
If you need more information on assigning gateway addresses,
refer to page 3-4.
5. Enter the optional Subnet Mask
If you need more information on selecting subnet masks, refer to
page 3-5.
6. After you have entered all the configuration data, save the file in a
directory where the BootP server can access it.
IMPORTANT
When using the BootP protocol, you must enter the
Ethernet hardware address of your module. Rockwell
assigns each 1756-ENBT module a unique 48-bit
hardware address at the factory. The address is
printed on a label on the side of the module. It
consists of six hexadecimal digits separated by dots,
as shown at left. This address is fixed by the
hardware, and cannot be changed.
00:00:BC:06:00:68
Ethernet Address
AB Parts