Manual
SmartHandle AX
7 / 55
SimonsVoss
3 | Safety instructions
3 Safety instructions
–
The batteries used may pose a fire or burn hazard if handled incorrectly.
Do not recharge, open, heat or burn these batteries. Do not short-
circuit!
–
Access through a door may be blocked due to defective or incorrectly
programmed products. SimonsVoss Technologies GmbH is not liable
for any consequences, such as blocked access to injured persons or
those at risk, physical damage or any other losses.
–
SmartHandle may only be used for its intended purpose: opening and
locking doors. No other use is permitted.
–
Only trained specialists may carry out installation and programming or
replace the batteries.
–
SimonsVoss Technologies GmbH accepts no liability for any damage
caused by incorrect fitting or installation.
–
drilling at own risk. SimonsVoss Technologies GmbH accepts no liability
for any damage caused. Observe safety instructions on drill.
–
Do not touch electronics/components; do not allow them to come into
contact with oil, paint, moisture, alkali or acids.
–
Only batteries approved by SimonsVoss may be used for battery
replacement.
–
Dispose of old or used batteries correctly. Store out of children's reach.
–
Check the polarity of the batteries.
–
Do not touch the contacts on the new batteries with your hands when
replacing the old ones. Use cotton gloves free of fat or grease.
–
The electronics must not be subject to mechanical stress or damaged in
any way.
–
Only use the SimonsVoss opening tool to open the housing.
–
SmartHandle AX only acts on the mortise lock latch bolt.
–
If the door needs to be secured for insurance coverage requirements,
then you need a self-locking panic lock (SVP lock) or a locking cylinder
in addition to the SmartHandle AX. Comply with the approvals as per
EN 179.
–
SmartHandle must be combined with a self-locking panic lock to
guarantee all functions work correctly. Observe the lock manufacturers'
Declaration of Conformity as per EN 179.
