Manual
SmartHandle AX
21 / 55
SimonsVoss
4 | Installation
1. Insert the switching plate as shown.
2. Position the spring sub-assembly at an angle to the escutcheon base
until it touches the switching plate.
3. Draw the spring sub-assembly back, so that the spring is compressed.
4. Slide the spring sub-assembly pawls into the escutcheon base.
5. Press the rear clip into the designated pawl.
ð
Spring contact is inserted.
Prepare inside
handle (DIN L)
Installation is different for each opening side (DIN R or DIN L).
1. Insert the switching plate as shown.
2. Position the spring sub-assembly at an angle to the escutcheon base
until it touches the switching plate.
3. Draw the spring sub-assembly back, so that the spring is compressed.
4. Slide the spring sub-assembly pawls into the escutcheon base.
5. Press the rear clip into the designated pawl.
ð
Spring contact is inserted.
Insert spindle
IMPORTANT
If you use a 7 mm spindle, attach the adapter shoe to the spindle before fit-
ting the spindle.
–
Insert the spindle into the outer sub-assembly until the pin locks into the
spindle.
ð
Spindle is inserted.
Fit sub-assembly
1. Push the sub-assembly with the spindle into the door from the outer
side.
2. Position the escutcheon base for the cylinder opening on the other side
of the door.
