April 1999
Page 7 of 17
Fleet Shower Room Assembly Instructions
The base, sacrificial runners, drain pan, floor-grating and related parts are
shipped from the factory as a sub-assembly. The following instructions are
to be used for reference purposes should any of these components need to
be replaced.
STEP 1.
BASE AND DRAIN PAN ASSEMBLY:
Refer to figure 3. Thread four 5/16"-18x2”, PC-
000167, stainless steel studs into the
threaded inserts on the underside of the
drain pan.
CAUTION: screw the studs in
by hand. Do not over-tighten, which
could rupture the drain pan or
strip the threads in the insert.
Be sure to have a clean work
surface that will not scratch the
top surface of the drain pan. Turn
the drain pan upside down with
the studs pointing up. Turn the
base upside down and place the open
rectangular area of the base with four slots in it
onto the four studs in the drain pan. Shift the base
around until the studs on the bottom of the drain pan go into the slots
provided in the base. Align the studs and slots so that they are
centred. Install a 7/16 flat washer PC-000126, a 5/16” flat washer PC-
000168 and then thread a 5/16” nylon lock nut PC-000173 on the end
of each stud. Stand the base and drain pan upright. Add the small
round flat shower drain strainer to the hole in the top centre of the
drain pan by slightly bending the tabs outwards and then insert it into
the hole.
STEP 2.
DRAIN PAN AND FLOOR GRATING ASSEMBLY:
Refer to figure 4. The floor grating is fastened to the drain pan
with four, hold-down clips SH1-0010 and four
#10 x 1 ½" oval head, self-tapping screws PC-
000158. The clips slide between the
vertical legs of the "T" extrusions as
shown and the screws are driven
in with a drill and crosshead drill
bit.
Figure 3
Figure 4
