April 1999
Page 14 of 17
Fleet Shower Model Assembly Instructions
STEP 15. SHELF FOR TOILETRIES:
Refer to figure 14. The shelf is
positioned around the shower tower
and on the second rib from the top
of the side panel. Slip the shelf
over and around the shower
tower so that it rests on the rib
of the side panel. On the
underside of the shelf, drill a
13/64" diameter hole through the
shelf and side panel, 2" from the
left inside edge and 1/2" up. Rivet
from the outside using a PC-
000102 rivet and PC-000106
back-up washer. Make sure the
shelf is level and drill another
hole on the right, underside of the
shelf 1 1/2" from the right inside edge
and 1/2" up. Rivet in place. Drill
another hole 3" over and 1/2" up from
this hole and rivet in place. Drill another
hole on the underside of the shelf one-half
way across the diagonal corner and rivet in-
place. Hold the inside lip of the shelf against the left side of the
shower tower, drill a 13/64" diameter hole and rivet in place with a PC-
000114 star rivet. Use the wash cloth hook as a drill guide and drill two
13/64" holes at about the centre of the large flat area on the shelf.
Rivet in place from the topside of the shelf with two PC-000100 rivets.
STEP 16. DOOR CLOSURE, CABLE CLIP:
Using the two remaining holes near
the middle hinge on the doorjamb as
drill guides, drill through the side wall
lip (that is in the groove of the
doorjamb) with a 13/64” drill bit
making sure not to drill all the way
through the doorjamb. Rivet the door
cable clip to the doorjamb using two
PC-000104 rivets as shown in figure
15.
Figure 14
Figure 15
