April 1999
Page 12 of 17
Fleet Shower Model Assembly Instructions
STEP 12. SHOWER TOWER ASSEMBLY TO DRAIN PAN:
Refer to figure 11. Remove the cap on the
shower head end of the long shower tower tube
and slip the end of the tube through the opening
in the roof. Place the bottom end of the long
tube over the moulded-in "boss" on the drain
pan. Rotate the shower tube so that the spray
pattern from the showerhead is directed away
from the door opening.
Drill a 13/64" diameter hole through the bottom
of the shower tube and into the "boss" and rivet
in place using a PC-000114 star rivet. Replace
the 3" cap above the roof on top of the long
tube, drill a 13/64" hole and rivet in place with a
PC-000114 star rivet.
STEP 13. FRESH WATER INLET PLUMBING:
Refer to figure 12. Apply Teflon tape to the PC-
000323 straight fitting and thread it into the 1/2"
FPT nipple on the shower tower assembly.
CAUTION: be sure to tape only the threads. Do
not allow any tape to get into the plumbing
system.
To determine the location of the
PC-100539 fresh water hose connector,
which is installed on the rear panel,
temporarily assemble the hose and elbow
and position them on the straight fitting.
Hold the hose and elbow level and make a
mark on the inside rear panel wall with a
pencil at about the centre of the pipe
thread end of the elbow where it touches
the rear panel.
ITEM #
PART #
DESCRIPTION
REQ.
1
PC-000102
Rivet, small flange, short
4
2 PC-100539
Connector,
water
hose
1
2a
PC-000102
Rivet, small flange, short
2
2b
PC-000106
Washer, back-up, 3/16"
2
3
PC-000324
Elbow, ½" MPT x ¾" hose barb
1
4
PC-000323
Fitting, straight, ½" MPT x ¾" hose barb
1
5 PC-000352
Clamp,
#12
2
6
SH1-0008
Hose, ¾"ID x 3 ½" long
1
7
PC-00106
Washer, back-up, 3/16"
4
8
SH1-0009
Cover, fresh water plumbing
1
9 SH1-0003
Shower
assembly
1
Figure 11
Figure 12
