ALL-FILL B-SV-600, User Manual

Page: 16 / 45

Controlling a Cutoff and Delay After Fill
The Setup Cutoff and Delay After Fill screen provides access to selections to control a cutoff
device (if used), and select a variable delay to occur after a fill cycle. A delay after fill can be
used to coordinate operation of the auger filler with other equipment, or to allow product to
settle and distribute into a container. Use the following procedure to control a cutoff device
and select a Delay After Fill in your Run Program.
1. Press MENU SCREENS and SETUP MENUS . Press EXIT . Use
è
until SETUP
CUTOFF AND DELAY AFTER FILL appears.
Model B-SV-600 Touch Screen Control Panel Users Manual
13
AFI Publication 1240410
•
Issue: 1
•
April 2010
2. Product cutoff devices that can be installed at the funnel of the filler can be controlled
using the
CUTOFF CONTROL selection. Types of cutoff devices used will vary with
design, product characteristics, and other accessories used at the filler. The following
types of cutoff control are available.
None – No Cutoff control required.
By Time – Specifies a period of time for the cutoff to open and close. The actual time is
specified in the OPEN TIME and CLOSE TIME entries.
Limit Switch – Specifies a period of time to delay the closing of the cutoff. The limit
switch determines cutoff opening and filling. The opening time is not selectable in this
mode.
Open Time – Specifies the amount of time that it takes to fully open the cutoff, prior to
the start of the fill. Entries can be made in this window only if cutoff control has been
selected as “Time.”
Close Time – Specifies the amount of time (delay) that it takes to fully close the cutoff,
after the fill is completed, can be specified. Entries can be made in this window when
cutoff control has been selected as either “Time” or “Limit Switch.”
3. Press DELAY AFTER FILL to coordinate operation of the auger filler with other
equipment, or to allow product to settle and distribute into a container.
4. When entries are complete, record settings on the Run Program Worksheet (see
“
Appendix ”) and press the
è
to continue.