Setting up Target Weight and Feedback Operation
The Setup Target Weight screen provides access to selections to define product name, tar-
get filling weight, and filling amount feedback operation. Use the following procedure to
specify these settings in your Run Program.
1.
Press
MENU SCREENS
and
SETUP MENUS
. Press
EXIT
. The
SETUP TAR-
GET WEIGHT
screen should appear. If not, use
è
/
ç
until the Setup Target Weight
screen appears.
Model B-SV-600 Touch Screen Control Panel Users Manual
10
AFI Publication 1240410
•
Issue: 1
•
April 2010
2.
Press
PRODUCT NAME
to associate a container, product, or batch with a particular
Run Program. Any alphanumeric character (0-9/A-Z) can be used, at up to 10 charac-
ters in length.
3.
The total amount of material to be dispensed during filling is defined with the
TARGET
WEIGHT
selection. You should enter the desired, final, filled weight. Feedback control
selections (see following) use this Target Weight value for feedback calculation and cor-
rection.
4.
Press
FEEDBACK CONTROL
to select the type of feedback used for correction of fill
weights. The following selections are available:
Servo
– Defines a raise/lower signal used as feedback to the filler. Typically, servo
raise/lower signals are provided by a checkweigher. When selected as “Servo” the
Feedback Sec./Wt. selection is used to specify how fill weights are corrected (see Step
5).
A&D Scale
– Defines a scale to provide feedback correction to the filler. When selected
as “A&D Scale” the Feedback Samples selection is used to specify how fill weights are
corrected (see Step 6).
None
– Feedback not used.
5.
If Feedback selected as “
Servo
” the
FEEDBACK SEC/WT
selection defines the
amount of time that is required to change auger revolutions based on weight value. This
value should match the same value on the weighing equipment.
