Manual
ASC3
Page 9
2.2.3 Setting Time of Day
When not finding any GPS, the ASC3 switches to
the manual setup for time of day. It shows the time
of day in hours, minutes and seconds. The first
digit blinks. Now you can set the time of day (see
below).
•
You can set the time of day only after you
switch the startclock on.
•
When the startclock is switched on, it first
scans for a GPS receiver and if it does not
find any it shows the time of day after 10 seconds.
•
The hours are blinking.
•
With the green push button PB1 (1) you can set the hours (0 to 23 hours).
•
With the yellow push button PB2 (2), you can switch to each following digit.
•
You use the green button PB1 (1) to also set the further digits (minutes and seconds).
•
If you keep the yellow push button PB2 (2) pressed for about 3 seconds, the time of
day is set and ready for synchronization. In the countdown clock field SnC is shown.
•
You synchronize with an impulse on the start input banana sockets (4) or by pressing
the green push button PB1 (1).
•
When the time of day is started you can set the program you want to use.
2.2.4 Setting the Program
•
After the synchronization, the time of
day display (F) shows the running time
of day for five seconds.
•
After five seconds the time of day disap-
pears and <ProgrA> is shown in the time
of day display (F).
•
The countdown display (E) shows the
last used program number.
•
With the green push button PB1 (1) you
can select the program number.
•
With the yellow push button PB2 (2) you can confirm the selected program number.
•
The startclock is now running in the selected program with the corresponding
countdown interval 1.
2.2.5
Select the Countdown Interval
As soon as the program is selected, you can
change the countdown time at any time. When
changing the countdown time the new countdown
time is calculated. Zero point for the new count-
down is always the zero tone of the last finished
countdown.
If you select the countdown interval and do not
change the interval time, the active countdown
continues without showing in the display. The
previous countdown only stops, when you select
a new countdown.
Summary of Contents for ASC3
Page 1: ...Manual Version E140514 ...
Page 39: ...Manual ASC3 Page 39 ...