Manual
ASC3
Page 8
2 Operation
2.1
Parameters
diSStt
.......... display start times and led/leg-times
............ print memory
StorE
............ select if you want to clear the memory
PrOGrA
.......... select the program (from 00 to 99)
LIgHt
............ start light adjustment
Horn
##
.......... speaker tone (# = Lo for low tone or Hi for high tone)
SEtUP
............ to clear the adjusted setup and reset to the standard parameters
gPS
................ when using GPS - offset of UTC (Coordinated Universal Time)
bIb
................ switch bib (start number) on or off
2.2
Starting up the Startclock
Switch the startclock on with the On/Off-Switch (11).
2.2.1 Memory
After the startclock is switched on you have the
possibility to clear the memory.
•
It shows <
StorE
> in the time of day display
(F) and <
YES
> in the countdown display (E).
•
With the green push button (1) you switch be-
tween <
YES
> and <
nO
>
•
YES
save memory
•
nO
clear memory
•
With the yellow push button PB2 (2) you con-
firm the selection to clear or save the memory.
2.2.2 Scanning GPS device
After the memory is cleared or saved, the message
<
SCAn gPS
> is shown. The next 10 seconds the
ASC3 scans the serial port to receive the time of
day from the GPS device. The baud rate is 9600. If
the GPS device is connected, the ASC3 waits as
long as it needs to receive a proper time packet
from the GPS. After the time is received the ASC3
is ready to select the program.
In order to stop the GPS scan press the yellow button PB2 (2). Now you can set the time of
day manually.
Attention:
If the wrong time of day is shown (e.g. 2 hours late), you have to adjust the offset
to the UTC (Coordinated Universal Time). This is done in the parameter setup <
gPS
>.
Summary of Contents for ASC3
Page 1: ...Manual Version E140514 ...
Page 39: ...Manual ASC3 Page 39 ...