ALFAMATIC Press-Right, User Manual, Page: 25 / 42

25
7 Scrap piece
When a scrap piece is detected, the tool crashes thus preventing the production of new pieces. In the
standard configuration, to reactivate the device, press the key.
In addition, if there is the scrap basket, the piece must pass through the sensor; the key allows
to open the cover, if present.
If the job includes multiple stages, the
Press-Right may require confirmation for the scrap materials.
If the range is not reached by the curve and there is no minimum height limit, the scrap is reported
for the minimum height
7.1 The discard causes
A piece can be good or scrap. The device may manage two discard signals to classify scrap
materials. The discard signal may be caused by one or more different causes. The following list
shows the possible discard causes.
MAXIMUM FORCE EXCEEDED
The maximum force reached exceeded the maximum force limit. The maximum force reached
does not match the force of the last curve dot.
MINIMUM FORCE NOT REACHED
The maximum force reached did not exceed the minimum force limit. The maximum force
reached does not match the force of the last curve dot.
BELOW THE LOWER EDGE
The curve passed below the range lower limit.
ABOVE THE UPPER EDGE
The curve passed above the range upper limit.
CANCELED FROM THE KEYBOARD
The job execution was interrupted by the operator by pressing the key.
EXECUTION INTERRUPTED
The START input was removed during the job execution. Usually it is caused by the activation
of the emergency procedures.
TIME ELAPSED
The job execution lasted too long. It is possible to increase the maximum time by reducing the
frequency of acquisition via the
CSQ Visual Setup software.
"ADDITIONAL" ABOVE THE MAXIMUM VALUE
The value of the additional transducer is higher than the additional maximum limit.
"ADDITIONAL" BELOW THE MINIMUM VALUE
The value of the additional transducer is lower than the additional minimum limit.
"ADDITIONAL" MONITOR
The additional monitor may cause the discard of scrap materials.
MAXIMUM HEIGHT EXCEEDED
The maximum height reached exceeded the maximum height limit. The maximum height
reached does not match the height of the last curve dot.
MINIMUM HEIGHT NOT REACHED
The maximum height reached did not match the minimum height limit or did not reach the
range. The maximum height reached does not match the height of the last curve dot.
HIGH INITIAL HEIGHT
The value of the initial height is higher that the maximum initial height limit.