10
Fitting Shaft Assemblies.
DuraCirc models 32 to 43 only:
1.
Lightly oil the rear bearing bores of the
gearcase (31) with gearbox oil.
2.
Fit first bearing circlip (60) in the inner
most groove in the rear bearing bore of
the gearcase (31).
3.
Locate the outer race of the rear bearing
(58) in the rear bearing bore.
4.
Fit second bearing circlip (60) in the outer
most groove in the rear bearing bore.
3206-0072
11
Replace the shaft shims (53) in to the bore
marked with a dimple (as viewed from the
front of the gearcase).
3206-0073
*
12
Identify the drive (51) and auxiliary (52) shaft
positions according to the gearcase cover (5)
orientation or original pump specification.
13
1.
Lightly oil the bearing bores of the
gearcase (31) with gearbox oil.
2.
Using a soft faced mallet tap the shafts
(51 and 52) into the gearcase (31).
NOTE: For Duracirc 52 to 74 pump models
ensure the outer race of the rear bearing (58)
is kept perpendicular to the rear bearing bore
to avoid hold up on the bore. Only light
tapping with a soft mallet should be used and
only if required. If the shaft does not easily
slide into the bore check bearing alignment
and front bearing tension.
3206-0033
200002348-1-EN-GB
36
5 Maintenance
EN
Summary of Contents for DuraCirc Range
Page 4: ......
