25
Fitting gearcase cover
1.
Remove all old gasket material from both
mating faces and wipe clean with a
solvent. Clean the bore of the gearcase
cover (35) and press a new lip seal (38)
into the cover until flush.
2.
Apply liquid gasket (such as Teroson
MS930 or similar) to the rear face of the
gearbox, ensuring the sealant is applied
to the inner side of the cover screw thread
holes.
3.
Apply a small amount of gearbox oil on
the inner lip of the lip seal and carefully
slide the cover over the shaft ensuring the
lip seal is centered and not cut or
damaged then secure with the gearbox
cover screws (42).
NOTE
It is recommended to allow the sealant time
to set before filling with oil. Follow the
recommendations of the sealant
manufacture.
3206-0039
26
Refit any blanking plugs (45) removed during
the disassembly checking the O-rings are not
damaged and replacing as required. Refit the
oil sight glass (44) in the side of the gearcase
(31) as shown. Refill with the recommended
oil (as stated in Section 4). Quantity
guidelines for each pump size and orientation
as given in Section 6.1 however oil should be
added to the gearbox until the sight glass is
filled with oil. Check the pump for any signs of
oil leakage and rectify as required.
3206-0000
!
200002348-1-EN-GB
42
5 Maintenance
EN
Summary of Contents for DuraCirc Range
Page 4: ......
