14
Fitting and retainers and gland guards
Clean the rear face of the seal retainers (14)
and the front face of the gearcase (31), fit in
position and tighten.
15
1.
Check rotor alignment is correct by
referring to the rotor abutment alignment
in step 18 and adjust as required.
2.
When rotor alignment is correct remove
seal retainers and press new lip seals (36)
until flush with front face.
3.
Lubricate with a small amount of lubricant
and fit a new O-ring (37) to the seal
retainer
4.
Apply a small amount of gearbox oil to the
inner lip of the lip seal (36) and push the
seal retainers into position. Make sure lip
seals are not damaged when sliding them
onto the shafts.
3206-0108
16
Position the gland guards (22) and tighten the
screws (40).
If the rotor abutment has been checked and
is within specification move to Step 20.
3206-0034
200002348-1-EN-GB
37
Maintenance 5
EN
Summary of Contents for DuraCirc Range
Page 4: ......
