Alert 650R, Installation Manual

Page: 6 / 43

. .
6
IMPORTANT NOTICE
COMPONENTS
• 1- Main Control Module
• 2- Four Button Remote
Transmitters
• 1- 6 Pin Ignition Harness
• 1- 5 Pin Harness
• 1- 10 Pin Mini Output Harness
• 1- 9 Pin Mini Input Harness
• 1- 2 Pin Valet Switch
• 1- 2 Pin Led Light Harness
• 1- 4 Pin Antenna Harness
• 1- 3 Pin Door Lock Harness
• 1- 4 Pin Shock Sensor Harness
• 1- Six Tone Mini Siren
• 1- Hood Switch
• 1- Hood and Window Decal
• 1- Installation Manual
• 1- Owners Manual
• Read the operation manual for operating and programming routine.
• Do not install any component near the brake, gas pedal or steering
linkage.
• Most vehicles have an SRS air bag system. Use extreme care and
do not probe any wires of the SRS system. These wires will almost
always be located inside a bright yellow tube located near the
steering wheel column.
• Check behind panels before drilling any holes. Ensure that no wiring
harness or other components are located behind the panels that
would otherwise be damaged.
• Do not use conventional crimp lock or bullet connectors on any
wiring.
• Do not disconnect the battery if the vehicle has an anti-theft radio
or is equipped with an airbag. Doing so may cause a warning light
to be displayed and the radio to stop functioning.
• Do not leave the interior or exterior lights on for an extended
period of time. Remove the dome light fuse from the vehicles fuse
box.
• Do not mount the control module until all connections have been
made and the unit is programmed and tested.
• Finally place the warning sticker under the hood when the installation
is completed.