Alert 650R, Installation Manual

Page: 28 / 43

. .
28
ALARM FEATURE #3 PROGRAMMING CHART
One Chirp with
Press One LED Pulse
Transmitter Factory Default Two Chirps with Three Chirps with Four Chirps with
Button Setting Two LED Pulses Three LED Pulses Four LED Pulses
6 + H8/5 Black/Red H8/5 Black/Red H8/5 Black/Red H8/5 Black/Red
Wire Channel 5 Wire Channel 5 Wire Channel 5 Wire Channel 5
Output= Output=Latched Output=Latched Output=Timer
Momentary Output Output and Reset programming (set
Output with Ignition “on” to any interval
between 1 sec-
ond and 2 min.)
7 + H8/2 Black/Violet H8/2 Black/Violet H8/2 Black/Violet H8/2 Black/Violet
Wire Channel 6 Wire Channel 6 Wire Channel 6 Wire Channel 6
Output= Output=Latched Output=Latched Output=Timer
Momentary Output Output and Reset programming (set
Output with Ignition “on” to any interval
between 1 sec-
ond and 2 min.)
Exit: Turn the ignition switch to the “ON” position, wait 15 seconds you
will get 3 long chirps and 3 parking light flashes, this will confirm the
programming has been exited.
Channels 4 (5/6) Timer Control Output Programming.
1. Turn the Ignition switch “ON” and “OFF” 3 times , then leave it in the
“OFF” position.
2. Press the valet/program switch 6 times and then hold it in on the
6th press until 3 chirps followed by 1 long chirp is heard and the LED
will turn on, release the valet/program switch . You are now in the
Alarm feature # 3
programming mode .
3-a . Press and release the transmitters and buttons together 4
times , [4] LED flashes and [4] siren or horn chirps will indicate
you are in “CHANNEL 4 TIMER PROGRAMMING MODE” .
3-b . Press and release the transmitters and buttons together 4
times , [4] LED flashes and [4] siren or horn chirps will indicate
you are in “CHANNEL 5 TIMER PROGRAMMING MODE” .
PROGRAMMING