. .
26
PROGRAMMING
2
. Press the
valet/program switch
4
times then hold it in on the
4th
press until
two chirps
with
1 long chirp
is heard, then release the
valet/program switch
. You are now in the
Alarm feature #2
programming mode
.
3
. Press and release the transmitters and
buttons
at the same time
twice,
[2] LED flashes
,
[2] chirps
to indicate the system is in the feature
Password Pin Code Programming mode
4
. Within 5 seconds, begin to enter your chosen first 9 digits by pressing and
releasing the
valet/program switch
from 1 9 times.
5
. Within 15 seconds of the last entered 9ths digit, turn the Ignition switch
to
ON
position.
6
. Within 15 seconds, enter your chosen second 9ths digit by pressing and
releasing the
valet/program switch
from 1 9 times.
7
. Finish by turning the ignition switch to the
OFF
position. If the new
password code was accepted, the unit will respond back with the newly
entered code, by flashing the LED, indicating the first digit code has been
memorized, pause and then the second digit code. The unit will repeat the
new code three times with a one-second pause between each code. Note:
If 15 seconds of inactivity expires, or if the ignition switch is turned
ON
for more then 5 seconds during the above steps, the unit will revert back
to the last successfully stored code.
[3] long chirps
will confirm you have
exited the program. The unit will revert back to the last successfully stored
code.
Delete Password Pin Code / Override Without a Password Pin Code
(Factory default setting):
1.
Turn the Ignition 'switch
ON and OFF
3 times and then to the
OFF
position.
2.
Press the
valet/program switch
4
times
and then hold in on the
4th
press until
two chirps
with
1 long chirp
is heard, then release the
valet/program switch
. You are now in the
ALARM FEATURE #2
PROGRAMMING MODE
.
3
. Within 15 seconds, press and hold the transmitters and
buttons
at the same time for 3 seconds.
1 long chirp
will confirm the Password
Pin Code is deleted.
Exit:
Press any button (except the
button
) of the transmitter to exit the
password pin set up mode.
ALARM FEATURE # 3 PRORAMMING:
1
Turn the Ignition switch
ON and OFF
3 times, then to the
OFF
position.
Summary of Contents for 650R
Page 1: ......
Page 7: ...7 INSTALLATION DIAGRAM Violet Wire Loop Selector for automatic or manual transmission...
Page 43: ......
