. .
32
PROGRAMMING
Exit:
Press the
button
on the transmitter.
3 long chirps
and
3 parking
light flashes
will confirm the program is exited.
IMPORTANT NOTE: You must program the Tach Signal before
trying to remote start.
ENGINE CHECKING TACH. / RPM LEARNING
1.
Turn the Ignition switch
ON and OFF 3 times
and leave it in the
OFF
position.
2.
Press the
valet/program switch
10
times
and then hold in on the
10
th
press until
5 chirps
with 1
long chirp
is heard, then release the
valet/program switch
.
3.
Press and release the transmitters and
buttons
at the same time
twice
[2] LED flash
,
[2] chirps
to confirm the system is in feature
RPM Learning mode
.
START FEATURE CHART #2
One Chirp with
Press
One LED Pulse
Transmitter Factory Default Two Chirps with
Three Chirps with Four Chirps with
Button
Setting
Two LED Pulses
Three LED Pulses Four LED Pulses
7 +
The Vehicle
The Vehicle has
The Vehicle has Built-in Turbo
without Turbo aftermarket Turbo aftermarket
Timer Control is
(The system
timer installed.
Turbo timer in-
Active: Press
cannot be
The system
stalled: The
+ buttons at
Arm with the
can be Arm with system can be
the same time to
engine is
engine running
Arm with the
set engine
running.
and the shock
engine running
running for one
sensor will be by- and the shock
minute.
pass as long as
sensor will be
the engine is
bypass for three
running.
minutes.
Five chirps
=Built-in Turbo Timer Control is active. Press +
buttons at the same time to control engine running 3 minutes.
Six chirps
=Built-in Turbo Timer Control is active. Press +
buttons at the same time to control engine running five min.
8 + Test Mode for Test Mode for
Zone 2 / Instant Zone 1 & Zone
Trigger & Zone 4 (2 Stage Shock
3 / Door Trigger Sensor)
Summary of Contents for 650R
Page 1: ......
Page 7: ...7 INSTALLATION DIAGRAM Violet Wire Loop Selector for automatic or manual transmission...
Page 43: ......
