Working With Configuration Files
Tutorial for Creating a Configuration File
OmniSwitch 6600 Family Switch Management Guide
April 2006
page 6-3
4
Use the
command to verify that the
dhcp_relay.txt
configuration file was
applied to the switch. The display is similar to the one shown here:
-> show configuration status
File configuration <dhcp_relay.txt>: completed with no errors
File configuration: none scheduled
Running configuration and saved configuration are different
Note.
If the configuration file applied with the
command results in no changes to the
saved configuration, the message will state that the running configuration and saved configuration are
identical
. To synchronize the running configuration and the saved configuration, use the
command.
For more information about these displays, refer to the
OmniSwitch CLI Reference Guide
.
5
Use the
command to verify whether the DHCP Relay parameters defined in the config-
uration files were actually implemented on the switch. The display is similar to the one shown here:
-> show ip helper
Forward Delay (seconds) = 15
Max number of hops = 3
Forwarding option
= standard
Forwarding Address:
128.251.16.52
These results confirm that the commands specified in the file
dhcp_relay.txt
configuration file were
successfully applied to the switch.
