Alcatel OmniStack 6124, User Manual

Page: 78 / 136

Web-Based Management
3-10
IP Configuration
Use the IP Configuration screen to set the bootup option, configure the IP address
for the on-board management agent, or set the number or concurrent Telnet
sessions allowed. The screen shown below is described in the following table.
Parameter Default Description
IP State USER-CONFIG Specifies whether IP functionality is enabled via manual
configuration, or set by Boot Protocol (BOOTP). Options include:
USER-CONFIG - IP functionality is enabled based on the default or
user specified IP Configuration. (This is the default setting.)
BOOTP Get IP - IP is enabled but will not function until a BOOTP
reply has been received. BOOTP requests will be periodically
broadcast by the switch in an effort to learn its IP address. (BOOTP
values can include the IP address, default gateway, and subnet
mask.)
IP Address 192.168.10.1 IP address of the switch you are managing. The switch supports
SNMP over UDP/IP transport protocol. In this environment, all
systems on the Internet, such as network interconnection devices
and any PC accessing the on-board agent (or running management
software) are assigned an IP address. Valid IP addresses consist
of four decimal numbers, of 0 to 255, separated by periods.
Anything outside of this format will not be accepted by the
configuration program.
Subnet Mask 255.255.255.0 Subnet mask of the switch you have selected. This mask identifies
the host address bits used for routing to specific subnets.
Gateway IP Address Gateway used to pass trap messages from the switch to the
management station. Note that the gateway must be defined if the
management station is located in a different IP segment.
MAC Address Physical address of the agent module.
Maximum Number
of Telnet Sessions
4 Sets the number of concurrent Telnet sessions allowed to access
the agent.