Alcatel OmniStack 6124, User Manual

Page: 13 / 136

2-1
Chapter 2: Using the System Configuration Program
Login Screen
Once a direct connection to the serial port or a Telnet connection is established, the
login screen for the on-board configuration program appears as shown below.
If this is your first time to log into the configuration program, then the default user
names are “admin” and “user,” both with a default password of “switch.” The
administrator has Read/Write access to all configuration parameters and statistics.
The user has Read Only access to the management program.
You should define a new administrator password, record it and put it in a safe place.
Select Console Login Configuration from the Management Setup Menu and enter a
new password for the administrator. Note that passwords can consist of up to 11
alphanumeric characters and are not case sensitive.
Notes: 1. Based on the default configuration, a user is allowed three attempts to enter
the correct password; on the third failed attempt the current connection is
terminated.
2. A banner message may be configured to appear before the Login screen.
The banner message is a login security alert. (See “Configuring the Banner
Message” on page 2-22.)
Alcatel OmniStack 6148
Alcatel Internetworking
26801 West Agoura Road
Calabasas, CA, 91301
(818) 880-3500
Alcatel OmniStack
Copyright (c), 2002 Alcatel and its licensors.
All rights reserved.
OmniStack is a trademark of Alcatel registered in
the United States Patent and Trademark Office.
Username :
Password :