Alcatel OmniStack 6124, User Manual

Page: 67 / 136

Monitoring the Switch
2-55
Configuring Static Unicast Addresses
Use the Static Unicast Address Table Configuration screen to manually configure
host MAC addresses in the unicast table. You can use this screen to associate a
MAC address with a specific VLAN ID and switch port as shown below.
Alcatel OmniStack 6148
< Static Unicast Address Table Configuration >
VID MAC Address Unit Port Status
------------------------------------------------------------
1 00-00-00-E8-43-12 1 1 Permanent
Sorted by : VID + MAC VID : 1 MAC : 00-00-00-00-00-00
VID : 1 Port : 1
MAC : 00-00-00-00-00-00 Status : Permanent
[Show] [More] [Set]
<OK>
Use <TAB> or arrow keys to move, <Enter> to select.
Menu Description
VID The VLAN group this port is assigned to.
MAC Address The MAC address of a host device attached to this switch.
Unit The switch unit the host device is attached to.
Port The port the host device is attached to.
Status The status for an entry can be set to:
Permanent
This entry is currently in use and will remain so after
the next reset of the switch.
DeleteOnReset This entry is currently in use and will remain so until
the next reset.
Invalid Removes the corresponding entry.
DeleteOnTimeOut This entry is currently in use and will remain so until
it is aged out. (Refer to “Aging Time” on page 2-53.)
Other This entry is currently in use but the conditions
under which it will remain so differ from the
preceding values.
Sorted by Selects the primary sort key for displaying table entries. Note that only
VID+MAC is implemented in the current firmware release.
[Show] Displays the static address table sorted on VID as the primary key and MAC
address as secondary key.
[More] Scrolls through entries in the static address table.
[Set] Adds the specified entry to the static address table, such as shown in the
following example:
VID : 1 MAC : 00-00-00-e8-34-22
Unit : 1 Port: 1
Status : Permanent