....................................................................................................................................................................................................................................
5-5
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
Cabling
....................................................................................................................................................................................................................................
NOTICE
ESD hazard
Semiconductor devices can be damaged by electrostatic discharges (ESD)
The following rules must be complied with when handling any module containing
semiconductor components:
Wear conductive or antistatic working clothes (for example, coat made of 100%
cotton).
Wear a grounded wrist strap.
Wear shoes with conductive soles on a conductive floor surface or conductive work
mat.
Leave the modules in their original packaging until ready for use.
Make sure there is no difference in potential between yourself, the workplace, and the
packaging before removing, unpacking, or packing a module.
Whenever handling ESD-sensitive components, do not touch any connection pins or
tracks.
Place modules removed from the equipment on a conductive surface.
Test or handle the module only with grounded tools on grounded equipment.
Handle defective modules exactly like new ones to avoid causing further damage.
These admonishments apply throughout this procedure. Refer to the Safety statements
chapter for general safety information.
Connect attached RF antennas
Use this procedure to attach and connect the attached RF antenna.
...................................................................................................................................................................................................
1
If a solar shield (without an RF antenna attached) is already attached to the 9764 CMCO,
then remove the solar shield from the 9764 CMCO by pressing the two levers (1 in the
figure below) and sliding the solar shield (2 in the figure) upwards. No tools are required
to do this.