....................................................................................................................................................................................................................................
4-7
Alcatel-Lucent – Proprietary
Use pursuant to applicable agreements
Installation
Pre-installation cabling
....................................................................................................................................................................................................................................
If...
Then...
View
You are connecting a daisy
chain cable in addition to the
cable from the backhaul system.
Align the daisy chain optical SFP
transceiver module with the SFP port
labelled “BH 2” and insert
the
module into the socket until you feel
the connector latch into place.
Attention:
If the SFP module resists as you insert it, do not force it. Remove the
module, turn it over, and try reinserting.
...................................................................................................................................................................................................
5
Push up and latch the SFP module locking bar into position to secure the SFP transceiver
module(s) into the port.
...................................................................................................................................................................................................
6
To check that each SFP transceiver module is seated and latched properly, grasp the SFP
module and try to remove it without releasing the latch.
If the SFP module cannot be removed, it is installed and seated properly. If the SFP
module can be removed, reinsert it until the module is latched securely into the socket.
E
...
N
...
D
.....
O
...
F
.....
S
...
T
...
E
..
P
...
S
.....................................................................................................................................................................
Connect the Ethernet cable
To connect the Ethernet cable(s) to the 9764 CMCO, perform the following steps:
...................................................................................................................................................................................................
1
Ensure that the Ethernet cable coming from the backhaul system to the 9764 CMCO is
correctly routed. If daisy chaining to a second 9764 MCO, ensure that the daisy chain
Ethernet cable is correctly routed to this 9764 MCO.
...................................................................................................................................................................................................
2
Unscrew and remove the rounded compression nut from the cable gland located on the
bottom of the bottom of the backhaul module.