Alcatel-Lucent 7710 SR OS, Interface Configuration Manual

Page: 298 / 436

Configuration Commands
Page 298 7710 SR OS Interface Configuration Guide
Parameters slow — Transmits packets every 30 seconds.
fast — Transmits packets every second.
lacp-xmit-stdby
Syntax [ no ] lacp-xmit-stdby
Context config>lag
Description This command enables LACP message transmission on standby links.
The no form of this command disables LACP message transmission. This command should be
disabled for compatibility when using active/standby groups. This forces a timeout of the standby
links by the peer. Use the
no form if the peer does not implement the correct behavior regarding the
lacp sync bit.
Default
lacp-xmit-stdby
mode
Syntax mode { access | network }
no mode
Context config>lag
Description
This command configures the mode of the Link Aggregation Group (LAG).
Parameters
access — Configures the mode as access for the LAG.
network — Configures the mode as network for the LAG.
port
Syntax port port-id [ port-id … up to 8 total] [ priority priority ] [ subgroup sub-group-id ]
no port port-id [ port-id … up to 8 total]
Context config>lag lag-id
Description
This command adds ports to a Link Aggregation Group (LAG).
The port configuration of the first port added to the LAG is used as a basis to compare to
subsequently added ports. If a discrepancy is found with a newly added port, that port will be not
added to the LAG.
Up to 8 (space separated) ports can be added or removed from the LAG link assuming the maximum
of 8 ports is not exceeded.