10
/ Swimming Pool Heat Pump Inverboost C
5.1.
Heat pump location
The unit will work properly in any desired location as long as the following three items are present:
1.
Fresh air
2. Electricity
3.
Pool water flow
The unit may be installed in virtually any outdoor location as long as the specified minimum distances
to other objects are maintained (see drawing below). Please consult your installer for installation with
an indoor pool. Installation in a windy location does not present any problem at all.
The maximum height at which the heat pump can be installed is 1 metre.
To guarantee the required efficiency, the maximum distance of the pump from the pool circulation
pump is 7.5 metres.
Location and connection
5.
ATTENTION:
Please observe the following rules when installing the heat pump:
1.
Any addition of chemicals must take place in the piping located downstream from the
heat pump.
2.
Always keep the heat pump upright. If the unit has been held at an angle, wait at least
24 hours before applying mains power to the heat pump.
ATTENTION:
Never install the unit in a closed room with a limited air volume in which the air expelled
from the unit will be reused, or close to shrubbery that could block the air inlet. Such
locations impair the continuous supply of fresh air, resulting in reduced efficiency and
possibly preventing sufficient heat output.
See the drawing below for minimum dimensions
Air inlet
Air outlet
Air in
Air out
