8
3
13
1
6
23
22
4. Transport
Normally, the viaplus is permanently attached to the wheelchair. If necessary for
transport, the system can however be dismantled into its individual components.
To do this, proceed as follows:
4. Removing viaplus from wheelchair
At the chassis:
Switch off the viaplus (see chapter 2.6).
Hold the plug [13] by the release sleeve and pull it from the socket [2] at
the chassis.
The control unit remains attached to the handle of the wheelchair.
At the rear of the battery pack [18]:
Using your thumb and index finger, push together the two locking mechanisms on
the plug [1] of the viaplus.
Disconnect the plug [1] from the socket [14] of the battery pack.
Remove the battery pack from the bag or box.
At the viaplus:
Retract the drive wheels (see chapter 2.7).
Hold the viaplus at the pedal [6].
At the wheelchair (both sides):
Push in the releasing device at the centre of the quickpin [13], using your thumb.
Pull the quickpin [13] from the bracket [22].
The viaplus is now detached from the wheelchair and can be removed by holding
it by the pedal.
To transport the unit, ensure that all components of the viaplus are properly
stowed away.
Observe the instructions for the transport of the viaplus and the wheelchair in
chapter 4.3.
•
•
•
•
•
•
•
•
•
•
•
•
•
GA-V12_GB.indd 13
26.05.2010 13:04:07
