Alaxala AX2400S series, Hardware Instruction Manual

Page: 19 / 249

Safety Information
Safety-5
Cut the DC power cable jackets to the specified length.

To use the DC power cable on the redundant power model, cut the cable jackets (on
the Switch side) to 8 to 10 mm.
Too short a sheath length might result in poor contact or a disconnected cable. On the
contrary, too long a sheath length might expose the core wire and cause an electric
shock.
Do not use the Switch with the protection cap removed.

Keep the protective cap in place except when attaching a cable. Otherwise, a fire or
an electric shock might be caused.
Note that EPU-B outputs higher voltage and the label shown below is therefore
attached near the standby power connector.
Handle power cables carefully.

Do not place anything heavy on a power cable. Do not pull, bend, or process a
cable. Doing so could damage the cable, resulting in fire or electric shock. If the
power cable is covered with a carpet or the like, it is easy to forget that the cable is
there and to place something heavy on it.

Use the supplied or a designated power cable. Using another cable could result in
fire or electric shock. In addition, do not use the supplied cable with other devices.
Doing so could result in a fire or electric shock.

If the power cable is damaged so that the wires underneath the covering are visible
or cut, stop using it, and ask maintenance personnel to replace it. Discontinue using
the cable to avoid the risk of fire or electric shock.

Make sure the power plug is free of dust, and insert the plug completely up to the
base of the prongs to prevent any looseness. Using a power plug with dust on it or
one that is imperfectly connected could result in fire or electric shock.
Do not overload the power outlet.

Do not overload the power outlet by connecting multiple power plugs to the same
outlet. Overloading the outlet could result in fire or the circuit breaker tripping due to
excessive power used. This might affect other equipment.
Prior to inserting or removing the power supply unit, disconnect the power
cable.

Prior to inserting or removing the power supply unit, disconnect the power cable from
the power supply unit. When the power cable is connected, part of the circuit is
energized even though the power switch is off. Therefore, inserting or removing the
power supply unit with the power cable connected can cause a fire or an electric
shock.