en
5
Initial assembly for 351VB I RB 3062 I RB 3081
1. Mount height-adjustable overrun device with
drawbar and axle on chassis.
2. Raise drawbar to the highest setting.
3. Release handbrake lever completely (A).
4. Pull the overrun device’s drawbar tube out fully
towards the front.
5. Screw drawbar tube (2) at least 15 mm into the
articulated head (1) of the overrun device and
lock with hex nut (3).
6. Pull the drawbar tube backwards until the relay
lever makes contact.
–
The cable pull needs to be tight.
–
The relay lever in the overrun device needs
to lie against the drawbar tube.
7. Hook bowden cable into the wheel brake (see
695100_a_bowden cable mount).
8. Connect bowden cables (8) with adapter
bracket (9) and lock with hex nut M16x1.5 (10).
9. Connect drawbar tube (2) with compensation
profile (7).
10.Pass bowden cables (8) into the compensation
profile (7).
11.Screw on ball nut M10 (14) and tighten. Lock
with hex nut M10 (15).
12.Connect the spacer (16).
13.Screw long nut (13) onto drawbar tube (2) and
tighten by hand.
14.Firmly apply and release the handbrake lever 3
times.
15.Turn the wheel forwards tightening the long nut
(13) until brake resistance can be felt.
–
The wheel needs to be turnable by hand in
driving direction.
16.Lock long nut (13) with hex nut (12) or alterna-
tively use linkage holder (11).
A
1
2
3
2
7
8
10
11
14
15
16
9
13
12
M
12
Tightening torques
M10
20-25 Nm
M12
40-45 Nm
M16
90-100 Nm
AL-KO linkage holder
Pull rod
Order no.
M10
228827
M12
28867601
