FS100™ PORTABLE SPRAYER SYSTEM
INSTALLATION, OPERATING, AND MAINTENANCE INSTRUCTIONS
FSG-MNL-00219
Akron Brass, Inc.
343 Venture Blvd.
Wooster, OH 44961
15
4. FILLING UP RESERVOIR
•
BEFORE STARTING, CHECK TO ENSURE THE
RESERVOIR IS EMPTY.
•
IF THE RESERVOIR IS NOT EMPTY, REMOVE
EXCESS LIQUID AND FLUSH THE SYSTEM WITH
WATER.
•
ONCE THE RESERVOIR IS CLEANED AND
EMPTY, USE THE 4-INCH OPENING ON TOP TO
FILL IT WITH THE DISINFECTANT
RECOMMENDED BY YOUR AHJ IN THE
CONCENTRATION COMPLIANT WITH THE EPA
LABEL AND THE FS100™CHEMICAL
COMPATABILITY LIST.
DO NOT POUR HOT OR BOILING LIQUIDS INTO
THE RESERVOIR.
WHEN MIXING LIQUIDS IN THE RESERVOIR, ADD
WATER FIRST, THEN THE CONCENTRATE, SO
THAT THE CONCENTRATE IS NOT SITTING
UNDILUTED IN THE RESERVOIR.
FOLLOW ALL SAFETY AND PPE GUIDELINES
LISTED ON THE SDS SHEET AND EPA LABEL
SPECIFIC TO THE DISINFECTANT YOU WILL BE
HANDLING.
5.
PRIMING THE PUMP
•
DISCONNECT THE WAND FROM THE END OF
THE HOSE, USING THE QUICK-CONNECT
FITTING.
•
PLACE THE END OF THE HOSE INTO THE TOP
OF THE 5-GALLON RESERVOIR.
•
LOCATE THE ON/OFF SWITCH ON THE UNIT
AND MOVE THE SWITCH TO THE ON
POSITION OR UP DIRECTION. YOU SHOULD
HEAR THE PISTON PUMP OPERATING AS IT
BEGINS TO CIRCULATE FLUID THROUGH THE
SYSTEM.
•
ONCE FLUID IS CIRCULATING THROUGH THE
SYSTEM AND BACK INTO THE 5-GALLON
RESERVOIR, TURN THE SWITCH TO THE OFF
POSITION OR DOWN DIRECTION.
THE PUMP
HAS BEEN PRIMED.
•
REMOVE THE HOSE FROM THE 5-GALLON
RESERVOIR AND RECONNECT THE WAND.
