FS100™ PORTABLE SPRAYER SYSTEM
INSTALLATION, OPERATING, AND MAINTENANCE INSTRUCTIONS
FSG-MNL-00219
Akron Brass, Inc.
343 Venture Blvd.
Wooster, OH 44961
13
7.
Turn the system back ON.
8.
Using the wand, depress the handle to spray the liquid. Adjust the nozzle to test different spray
patterns.
9.
Depress and release the handle several times to make sure the spray pressure is consistent each
time and that the liquid stops flowing as expected.
10.
Inspect the wand and hose assembly for leaks. Use the Troubleshooting section of this manual
to help address any problems.
11.
Depress the handle until all the water in the reservoir is used.
Turn the system OFF.
12.
Remove the cart from the storage container and open the container lid. Inspect for leaks. Use
the Troubleshooting section of this manual to help address any problems.
13.
Close the container lid and cap the reservoir.
The unit is ready for use.
System ready for priming operation.
Wand Nozzle Tip Selection
Three nozzle tips ship with each unit and each nozzle is stamped with a number. The 11001 nozzle is
installed on the unit. Use the table below to help select another nozzle, based upon the desired
flow conditions. Refer to the Maintenance Instructions for assistance in cleaning, changing, or
inspecting the nozzle tips.
