58
IoHD Tab Screen
AJA Control Panel, IoHD Tab
IoHD Stand Alone Mode
—while connected to the Mac, Io HD can be configured
for a set of parameters and then disconnected from the Mac for use by itself as a
stand-alone converter. An example would be using the Io HD in Stand Alone
Mode as an SD to HD upconverter.
To use the Io HD in this way, select the Io HD
Stand Alone Mode
pulldown
from the
Control
tab screen. Next, select
Current Setting
or
Factory Setting
.
Factory Setting is the factory default settings as shipped from AJA. Selecting
Current Settings means using the exact settings currently configured on the AJA
control panel when in standalone mode. After choosing one of these selections,
click the
Burn...
button to save the settings into Io HD’s non-volatile memory
for use unconnected from a Mac.
After doing so, there will be a short time to complete the internal process—and
then you may power down and disconnect the Io HD. From this point, the Io
HD is a stand alone converter and will retain the parameters selected when it is
powered back on. The Io HD remains in Stand Alone Mode until it is once
again connected to a Mac via FireWire. Turning it ON and OFF will not take it
out of Stand Alone Mode until is again connected to a Mac via FireWire.
Note:
The AJA Io HD can also be used as a converter device while it is connected
to a Mac if the
Default Video Output
in the
Control
tab of the Control Panel
application is set to
Input Passthrough
.
Summary of Contents for io hd
