30
When planning equipment locations and mounting methods, take into account the
weight and size of the chassis:
•
Chassis Dimensions:
Height—4.8” with rubber feet (121.9 mm)
Depth—12” (304.8 cm)
Width—8.2” (208.3 cm)
Power—100 to 240VAC, 50/60Hz, 35 Watts
Warning!
Do not open the chassis. There are no user-serviceable parts inside. Opening the
chassis will void the warranty unless performed by an AJA service center or
licensed facility.
Cabling the System
Where to Place Io
HD
•
Plan adequate space for cable routing from the back of the chassis. Ensure that
cable connectors are not stressed and that cables are not bent or crimped.
•
When rackmounting, place it securely on a rack shelf, allowing adequate
airflow to both it and equipment above and below it. Note the location of
cooling vents on all equipment and ensure none are obstructed.
•
Place the Io HD chassis where temperature and humidity are moderate.
System Video/Audio Cable Connections
When installing your system, you’ll make audio and video input/output
connections. These connectors are explained individually in chapter 2. Here, system
interconnection is shown and described.
The Io HD chassis should be plugged into AC power before you make connections
— although it
should not
be switched on. The AC cord provides a path to ground
for accidental static discharge and protects system equipment.
Typical Digital System
A figure on the following page shows typical system interconnections for a system
with digital A/V sources. Your system may differ depending on VTRs, audio
monitoring, and video monitoring.
1.
If desired, connect your house reference sync/blackburst generator to the Io
HD
Ref
connector (BNC). The second Io HD Ref (out) connector can be
connected to your VTR or terminated with a 75 ohm terminator (also
optional).
2.
Connect a Video Monitor to the Io HD
Component Analog Video Out
BNC
connectors (preferred), or instead connect to any available video output for
monitoring (all are active).
Summary of Contents for io hd
