22
Optical Fusion Splicer Instruction Manual
b.
Align the optical fiber coating layer edge to appropriate scale
mark, place optical fiber into oriented rolling groove of holder,
and confirm that bare optical fiber is straightly placed on the
clamp pad.
c.
Close clamps cover of holder first then close the top clamp
cover slowly, quickly push the sliding plate with blade to
another side, and finish optical fiber cleaving.
d.
Open the top clamp cover first, then open holder clamp cover
while holding optical fiber by another hand, flick off
fragmentary optical fiber, and carefully remove the optical
fiber from cleaver.
e.
Take out and place the fiber chips into chips collector box.
f.
Indoor fiber cleave process is similar.
Note:
Optical fiber sections after cutting must keep off any other
objects, in order to guarantee splicing quality
.
The cleaver of bare fiber is different from indoor fiber, so please
use the corresponding cleaver for different fiber.
5.5 Loading Optical Fiber to Splicer
a.
Open wind protector cover and fiber platen on left and right
sides of splicer. Check the V-groove, clean it if there is some
dust.
b.
Place prepared optical fibers onto v-groove and ensure the
