Use and maintenance manual Self-propelled aerial platforms Page 12
3
SAFETY PRECAUTIONS
3.1
Power supply
The electric and hydraulic circuits and the fuel supply circuits are provided with safety devices, calibrated and sealed by the
manufacturer.
Do not tamper with and modify the calibration of any component of the electric and hydraulic system.
3.2
Work and maintenance rules
-
Always wear personal protective clothes according to current regulations concerning industrial health and safety (in
particular, helmet and safety harness are COMPULSORY. See picture below).
-
The machine must be used only in areas well lit up, checking that the ground is flat and firm. The machine may not be
used if the lighting conditions are not sufficient.
-
Do not use the thermic power (Diesel or Petrol engine) indoors or in insufficiently ventilated areas.
-
Before using the machine check its integrity and conservation state.
-
During maintenance operations do not dispose of any waste materials in the environment, but comply with current
regulations.
-
Do not carry out any service or maintenance operations when the machine is connected to the power supply. Follow the
instructions given in the following paragraphs.
-
For the maintenance of the heat engine (Diesel or Petrol engine) supplement the instructions given in this manual with
those given in the heat engine manual.
-
Do not approach the electric and hydraulic system components with sources of heat or flames.
-
The platform is intended for people carriage; therefore, it is necessary to comply with the current local regulations
relevant to this class of machines.
-
Do not increase the max. allowed height by means of scaffolds, ladders or other.
-
Do not use the machine as a crane.
-
Do not use the machine as a hoist and/or lift.
-
Protect the unit (in particular the platform control panel) and the operator when working in adverse environmental
conditions (painting, de-painting, sand-blasting, washing, etc.).
-
It is forbidden to the unit in case of severe weather conditions (rainstorms with wind exceeding the limit speed indicated in
chapter "Technical features”).
-
In the event of rain or in parking condition always protect the on-platform control panel by means of the specially provided
cap.
-
Do not use the machine in areas where risks of fire or explosion exist.
-
Before using the unit with levelling jacks ALWAYS check the firmness of the ground and the correct operation of the
levelling jacks by lowering them completely and verifying that they stay in position and that the ground does not subside.
-
When using the levelling jacks always place strong wooden boards under the levelling jack pads so as to spread the load
on a wider surface.
-
Do not use pressurized water jets (high-pressure cleaners) to wash the machine.
-
In the event of Diesel engine fault, contact the nearest service centre. Do not carry out any repair to avoid burns or
damage.
Fig.3
